Piscine Poolcontrol • Piscine din polipropilena • Piscine din beton
Dezinfectare apa Piscine de la Poolcontrol
   

AQUALYSE SALT CHLORINATORS

Your pool water should be lightly salted (4 to 5 g/l i.e. 8 times less than sea water). The chlorinator uses electrolysis to break down the salt and generate chlorine that will sanitize the water. The chlorine is ultimately converted back to salt.


The Aqualyse salt chlorinators ensure a perfect disinfection of your pool water with no chemical products.

  1. Easy to use and autonomous for a totál tranquility
  2. Crystal clear and non-aggressive water under all circumstances
  3. No eye irritation or dry skin
  4. No need to use nor store chemical products
  5. Destroys bacteria, microorganisms and algae

For optimum efficiency the pH must be maintained between 7.0 and 7.4.

Comfort

  1. Available for almost any type of pools, up to 120 m3
  2. Can be installed on new filtration or adapted on existing pools
  3. Disinfectant production adjustable (3 levels)
  4. Self cleaning cell by polarity inversion
  5. Compatible with any pH controller
  6. Shipped ready to use for a simplified installation

Reliability

  • Long life cells with an unsurpassed solidity
  • A simple electronic box minimizing the risk of misuse

Security

  • Water circulation detection and control (flow sensor built into the cell)
  • Lightning protection and resettable circuit breaker in case of over voltage

 

 1

Technical characteristics

  1. Power supply: 230 V / 50 Hz single phase
  2. Dimensions (electronic box): H 255 mm / W 180 mm /DlOOmm
  3. Weight electronic box: 3.5 kg
  4. Cell 3 plates (Aqualyse 30), 7 plates (Aqualyse 80) or 10 plates (Aqualyse 120)
  5. Solid plates electrodes Titanium / Ruthenium
  6. Cell length: 290 mm without the fittings
  7. Cell resistant to 5 bar pressure peak
  8. Direct or by pass installation of the cell
  9. Water flow: up to 16 m3 per hour if direct Otherwise, by pass installation recommende
  10. Ideal salt rate: between 4 g/l and 5 g/l
 
Product Range AQUALYSE 30 AQUALYSE 80 AQUALYSE 120
Water volume Up to 30 m3 From 30 m3 to 80 m3 From 80 m3 to 120 m3
dezinfectare apa

DIGI PH CONTROLLER

The pH is a key parameter of the water balance. It should ideally be maintained between 7.0 and 7.4 for the comfort of bathers but alsó for the effectiveness of the disinfection.
The pool water can be acidic or basic depending on the characteristics of the water used and the type of treatment. It is imperative to monitor weekly the water pH for bathing and regularly correct this level.

Aqualyse Digi pH performs these tasks automatically and permanently for you. It measures continuously the pH and injects the necessary doses to maintain an ideál pH.

Aqualyse Digi pH continuously regulates the pH of your water so it's always perfect.


Confort

  1. Available for almost any type of pool, up to 180 m3
  2. Can be installed on new filtration or adapted to existing pools
  3. Continuous digital display of pH
  4. pH+ or pH- correction mode
  5. Shipped ready to use for a simplified instál lation
  6. Adjustable set point (7.2 or 7.4)
  7. Pre calibrated with all accessories

Reliability

  • Professional pH probe
  • A simple electronic box minimizing the risk of misuse

Security

  1. pH self security test
  2. Automatic anomaly detection (empty can, faulty sensor, treatment product error,...)
  3. Simple management procedures (to exit safety mode, recalibration) without electrical manipulation

 

2

Technical characteristics

  1. Power supply: 230 V / 50 Hz single phase
  2. Dimensions (electronic box):
  3. H 200 mm / W 150 mm / D 90 mm
  4. Weight electronic box: 910 g
  5. Maximum flow rate: 2.21 / hour
  6. Display: LCD with an accuracy of 0.1
  7. Peristaltic pump
  8. Maximum back pressure: 1.5 bar
 
 
 
 
   
 
Piscine Poolcontrol - piscine din poliproplena si din beton | 410175 Oradea, str. Sportului nr. 22 | Telefon/fax: 0259/457.328 | office@poolcontrol.ro
Arta si cultura SEO Romania Smarty Web Director
Powered by INTERGATE